23
Note
In GSM mode, the audio monitoring is not limited in time.
Hard Reset
Press the Connect button and the Panic button (SOS) simultaneously. Release them after 3 beeps.
Wait 10 seconds. The panel beeps twice: the system is restored to default setings.
Stored phone numbers and accessories will also be deleted.
Zone setup of accessories
Every detector can be assigned to 4 different categories of zones: Home Mode Zone, Delay Zone,
Normal Zone and 24-H Zone. To assign a detector to a zone, open its case and move its jumpers
according to the drawing below:
A.
Home Mode Zone
B.
Delay Zone
C.
Normal Zone
D.
24-H Zone
Normal Zone
When the system is armed, if a sensor is triggered, the siren rings out. When the system is
disarmed, sensors do not trigger an alarm.
24-H Zone
Regardless the system is armed or disarmed, sensors assigned to the 24h zone can trigger an
alarm.
It is recommended to set smoke detectors gas detectors and outdoor beam sensors in the
24-H zone
.
Delay Zone
An entry and an exit delay can be set.
In such case, sensors assigned to the “Delay Zone” will not
trigger an alarm during the time of delay set. For example, if you assign a motion detector to the
Delay zone and you set the Entry/Exit Delay to 30 seconds, the motion detector will not trigger an
alarm within 30 seconds after you enter your home and within 30 seconds before you leave it son
that you can leave and enter your home without triggering an alarm. Refer to the instruction on
page 27 of this manual to learn how to set the entry and exit delay.
It is recommended to assign
the Door / Window Contact to the Delay zone.
Home Zone
When the system is armed in Home Mode, the sensors assigned to the Home zone do not trigger
an alarm.
It is recommended to assign motion detectors to the Home zone so that you can have
your system armed in Home Mode when you are home and move inside your home without
triggering any alarm.
SMS OPERATIONS