The floating cable has
excessive tangling
Too much cable in the water.
Place only the required amount of cable into
the water to allow it to reach the farthest end
of your pool with remaining cable on the pool
deck. (See: Install and Submerge the Cleaner)
Removal needed
Untangle the twisted cord and lay in sun to
reduce memory. (See: Cord Tangling).
User Issue
Possible Cause
Suggested Solution
The cleaner is not cleaning
the pool effectively.
Filter canister is full or dirty.
Dispose of debris and thoroughly clean the filter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner (see: Clean the Filter
Canister).
Brushes are worn.
Check the wear indicator(s). Contact your local
dealer for spare parts.
Cable is excessively tangled.
Untangle the twisted cord and lay in sun to
reduce memory. (See: Cord Tangling).
Dismissing an Error Code
From the Control Unit:
After you have completed the troubleshooting solution steps, press any key (except the phone icon) to
clear the error code.
If the control unit is in Standby Mode, press the Start/Stop button to show the on-screen display. After
you have completed the troubleshooting solution steps, press any key (except the phone icon) to clear
the error code.
From the iAquaLink
™
App:
Press the error icon to display troubleshooting solutions. After you have completed the troubleshooting
solution steps, press Clear Error to return to normal operation. Or, press OK if you need to complete
the solution steps at a later time.
iAquaLink
™
Troubleshooting
This information can help to troubleshoot connection and setup challenges between the iAquaLink app
and the cleaner.
How It Works
Your
Smart
Device
Your
Internet
Router
Cleaner
Control
Unit
Robotic
Pool
Cleaner
Internet
Page
34
Zodiac
®
VX65iQ Robotic Pool Cleaner
|
Owner's Manual