22
The screen displays the message
when the remote control
mode is active
•
This means that the remote control batteries are too low: change them.
The remote control LED is flashing
slowly or the LED is steadily lit.
Remote control range problem:
•
Position the control box on the caddy at least 3.5 metres from the pool.
•
Orient the control box towards the pool in order to improve the range of the
remote control. Ensure there are no large obstacles between the control box
and the pool.
The remote control LED is steadily
lit.
•
Synchronisation problem: repeat the synchronisation steps (see § « 2.7.4
Synchronising the remote control with the control box »).
If the problem continues contact your retailer:
4.2 I User alerts
User alerts (depending on the model)
Solutions
Flashing LED:
Error code:
Er: 10
•
Check that the cleaner is correctly connected to the
control box. If necessary, unplug it and reconnect it
following the appropriate procedure.
Er: 02
Er: 03
Er: 05
Er: 06
•
Check that there is nothing preventing the brushes
and wheels from turning. To do so, turn the wheels
(1/4 turn) to release any debris that may be jammed.
Er: 07
Er: 08
•
Cleaner operating outside the pool. Make sure you
start the cleaner when it is in the water (see § « 2.1 I
Immersing the cleaner in the pool »).
Er: 01
Er: 04
•
Check that there are no stones or hair in the propeller.
•
Clean or change the filter if necessary.
If the problem continues contact your retailer:
Error codes
•
Pressing a key deletes the error code and turns off the control box.
•
The screen switches to standby after 10 minutes. To turn the screen back on, press any key.
•
When an error is detected, the control box temporarily suspends the programme (the
LED is turned off).
•
Press and hold the
key to re-confirm the current programming.
EN
