4
INSTALLATION GUIDE
The following steps will help you get up and running with your new Zodiac
TRi Chlorine generator.
POSITIONING THE POWER PACK
1. Locate a suitable space for the power pack bracket. It should be
installed no further than 1.8 meters away from the cell - ideally in a
filtration shed or close to the filtration equipment.
PLEASE NOTE: if fixing to a post it must have a waterproof panel fitted (behind the unit),
at least 450mm wide and 470 mm high.
2. Using screws provided, fasten the bracket securely to the wall and
position the power pack on the bracket. Plug into power point, but
don’t turn on the power.
POSITIONING THE CHLORINE GENERATING CELL
PLEASE NOTE: The cell should always be the last device placed on the water pipe
(In the return line to the pool).
3. Ensure the cell is placed horizontally, with the Inlet pipe connecting to
the fitting closest to the cell lead.
4. Using screw barrel fittings (supplied), attach the cell to the pipe. If using
40mm pipe, you will need to fit the cell using the reducing bushes (also
supplied).
5. When connecting the lead from the power pack to the cell match up
the corresponding colours and pins, then fit the end cap.
(Note: Either RED wire can be connected to either RED pin on the electrode.)
6. Plug your pool pump into the outlet socket in the bottom of the TRi
(this will allow the TRi timer to control the filtration times)
7. Once all connections are together press the mains power switch to ON.