55
Message
Possible cause
Solution
"---"
displayed
where
the ORP value
should be
Example display:
- - -
•
The pH value measured is greater than 12.
•
The sensor has been automatically blocked
by the pH overdose safeguard.
•
Check the connection between the sensor
and the control box, re-connect if necessary
(contact your retailer)
.
•
While waiting for a replacement sensor,
deactivate the ORP function in the service
menu in order to switch to manual operating
mode (contact your retailer)
.
"pH dosing
STOP"
(
“INFO”
indicator
flashing)
•
The pH value measured remains higher
than the pH setpoint despite an injection
cycle customised by the pH overdose
safeguard.
•
Check or replace the container.
•
Check and adjust the alkalinity (TA) of the pool
water.
•
Check/clean or replace the pH sensor.
Tip: if you require assistance, inform your retailer about the appliance's condition to save time
8.2 I Wi-Fi LED behaviour
Control box status
Meaning
• The
LED is off
•
Appliance not connected or Wi-Fi network issue (modem malfunction,
changed network name or password, etc.)
•
Repeat the pairing process. If the LED is still not lit despite the pairing attempt,
disconnect the reconnect the appliance to the mains power supply.
• The
LED is flashing
•
Pairing in progress. To stop pairing, disconnect the appliance from the power
supply.
• The
LED is on steady
•
Appliance connected to the Wi-Fi network and accessible via the app.
•
Pairing can be restarted regardless of the connection status by simultaneously pressing
+
for
4 seconds.
EN
