Page 17
Page 16
eXO
®
| Installation Manual
Section 7. Operation
7.1 User Interface Overview
CAUTION
Before activating the chlorination function of your system, ensure that all salt added to the pool has completely dissolved.
User Menu
Browse current menu;
Increase or decrease a setting;
Lock/unlock the UI (press and hold both)
On, Off
Standby mode
Enter the highlighted selection;
Delete an error message
(press and hold 4 seconds)
Activate reduced
chlorine production mode
Activate 100% chlorination for
24 hours*
LED indicates information or
error message on screen
LED indicates low salt/minerals
or poor water conductivity
*The filter pump will also operate if filtration pump is connected to the controller
Figure 22. Controller User Interface
7.2 Initial start-Up
The following setting must be configured at the
initial start up of the device. Settings can be
changed or updated at a later time using the
general menu, details can be found in Section 8.
From factory, the chlorination is set at 50 %. It can
be set between 0 and 100 % in 10 % increments
from the “main screen” by pressing
. The set
value is valid until the next modification.
7.2.1
System Power
1. Press
to enter Standby mode.
2. Press
again to start chlorination and
filtration.
3. Press and hold
for 3 seconds to turn the
controller off.
7.2.2
Language
1. Press
.
2. Use
to select “Language”
then press .
3. Use
to browse language the options.
4. Press to make a selection.
<
-LANGUAGE
MAIN MENU
<
-ENGLISH
-FRANCAIS
-ESPANOL
-ITALIANO
-DEUTSCH
-NEDERLANDS
-PORTUGUES
-CESTINA
-MAGYAR
-SVENSKA
-SLOVENSKY
SELECT LANGUAGE
7.2.3
Set Clock
1. Press
.
2. Use
to select “Programming”
then press .
3. Use
to select “Clock”
then press .
4. Use
to set hour then press .
5. Use
to set minutes then press .
NOTE: Press and hold
or to increment time by 10.
6. Press
to exit.
<
-PROGRAMMING
-LOW MODE
-SLAVE MODE
MAIN MENU
23:04
CLOCK SET UP
7.2.4
Boost Mode
In some cases, the pool may require a higher than
normal chlorination level such as in cases of high
use, poor weather or at the start of the season. Boost
mode is used to increase the chlorine level quickly.
Boost mode lasts for 24 cumulative hours at 100%
production output. If the program is set to perform
chlorination 12 hours per day, Boost mode will be
active for 12 hours on the first day and 12 hours
on the second day. If the filter pump is connected
to the controller, the filter pump will operate in
Boost mode also. The controllers operating times
including filtration schedules are temporarily
Wi-Fi to phone connection
