ZNEX Notstrom, User Manual

Page: 6 / 12

Tarn (Stealth) Mode Stand-by Mode
EN
You can hide the LED display at any time.
If notstrøm is being charged or a device is
connected to it for getting charged, the LED
display will automatically switch on.
In certain situations, you might want to make
the LED lights invisible.
If you prefer to switch off the LEDs, simply
click on the ON/OFF button. The LED lights
will now disappear without affecting the
charging function of notstrøm.
Note:
The LED display can be switched on again
by clicking again on the ON/OFF button.
If the charging cable is screwed on and you
switch on notstrøm, it will automatically enter
the active stand-by mode.
Connect a device for charging now and it will
be continuously supplied with power.
Automatic switch-off does not take place after
the device is completely charged.
The stand-by mode makes it convenient to
use the ØM3 on a bicycle and also guarantees
continuous power supply of outdoor
monitoring equipment for long periods of
time such as GPS-Trackers, USB motion
detectors, wild cameras etc.
Note:
If the stand-by mode is disabled, you should
either switch off notstrøm or remove the
connected cable.
Weather resistance
notstrøm is only protected against rain, snow,
dust and sludge when both its protective caps
are closed
or the connection cable is tightely screwed.
iP67
Input protective cap
iP68
Output protective cap
iP68
Plug connection
Warning:
Malfunctioning or short circuit might occur
if water or even very small quantities of
impurities (sand, dust, dirt) enter the device.
Clean the plug connection and protective
cap therefore after using it. Please ensure
that the plug and the protective cap are
always kept dry and clean when you connect
the plug with notstrøm or put the protective
cap on.