ZMC408SCAN Hardware Manual Version1.2
13
The closure of output will be affected obviously by external load circuit because of OD
output, and the output frequency in application should not be set too high. It is recommended
to set below 400kHz for high-speed output and below 8kHz for general output. If higher
speed is required, please contact us to adjust parameters or to customize the hardware.
2.2.4.3
Digital Output Wiring Example
2.2.5
AD/DA analog terminal
PIN
Signal
Description
2
DA0
Channel 0 outputs, 0-10V, resolution 12-bit
1
DA1
Channel 1 outputs, 0-10V, resolution 12-bit
3
AGND
Analog reference ground
5
AD0
Channel 0 inputs, 0-10V, resolution 12-bit
4
AD1
Channel 1 inputs, 0-10V, resolution 12-bit
DA output outside connects load resistor ≥1KΩ.
