ECI0064 Network IO Control Card User Manual V1.5
3.4.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please use any ETHERNET or RS232 (there is default parameter,
which can be connected directly) to connect to ZDevelop.
(3)
Please use the "ADDRESS" and "SETCOM" commands to set and view the protocol
station number and configured parameters, see "ZBasic Programming Manual" for
details.
(4)
According to their respectively instructions, correctly set the relevant parameters of
the third-party equipment to match the parameters of each node.
(5)
When all is configured, it can start to do communicating.
(6)
Communication data of RS232 can be directly viewed through “ZDevelop
/ Controller
/ State the Controller / CommunicationInfo”.
3.5.
ETHERNET
ECI0064 network IO control card has an Ethernet port, and it supports MODBUS_TCP
protocol and custom communication, and the default IP address is 192.168.0.11. The pin
definition is as follows:
Summary of Contents for ECI0064
Page 1: ......
