Zmartgear ZMG060, Manual

Page: 5 / 16

Safety Guidance
●
Persons who install and use chargers must observe the
principles and regulations to ensure safety. Before using charger,
the electrical infrastructure should be checked by qualified
electrician for suitability. Electrical infrastructure must comply
with the charger specifications.
●
Before turning on the unit, make sure that the unit is properly
grounded to avoid unnecessary accidents.
●
Do not use wire extentions or adapter/convertors.
●
Before charging always carry out a visual inspection for
damage. The contact area of the charging plug should be free
from dirt and moisture, the charging cable should not have cuts
or abrasions of the insulation and the cable outlet of the charger
must be checked to ensure that it is firmly seated.
●
Unauthorised modifications, changes or repair of the charger is
strictly prohibited and it leads the immediate exclusion of the
warranty.
●
The charger must not be used in the vicinity of volatile gases or
flammable objects.
●
Strictly forbidden for children to touch or use the device. Do not
let children get close when using it.
●
Disconnect the charger only by the plug and not by the cable.
●
Do not disconnect the charger during the charging.
●
Only remove the charging label by the plug and not by the cable
of the power outlet.
●
Only change the accessory adapters when the power supply is
disconnected.
●
Stop using the device immediately when charging failure or
abnormality occurs.Strictly forbidden to use the equipment in
thunder and lightning weather.
Protect from moisture, rain, sunlight and corrosive environment.
Strictly forbidden to submerge AC charging device in water.
This product is only used for charging electric vehicles, not for other
purposes.
Product Overview
Zmargear portable EV charger is a household charging device for
electric vehicles. Its appearance is shown in Figure 1 and its
plug options is shown in Figure 2. The product meets the
requirements of IEC 61851-1:2017 and IEC/EN 62752:2016 Mode 2 AC
charging system. One end is an AC charging connector that
meets EN 62196-2:2017 and SAE J1772, the middle is an control box
on the cables, and the other end is a power plug.