9
Cycles
OPERATION
HOW YOUR DISHWASHER CLEANS
• Your dishwasher cleans by spraying a mixture of hot water and detergent through the
spray arms against soiled surfaces.
• The dishwasher fills with water covering the filter area. Water is then pumped through
the multiple filter system and spray arms. Separated soil particles go down the drain
as the water is pumped out and replaced with clean water.
• The number of times water fills inside the tub will vary with the cycle being used.
WASH CYCLE SELECTIONS
• Cycle times are approximate and will vary with the options selected. Hot water is
necessary to activate the detergent and melt fatty food soils.
• An automatic sensor will check the incoming water temperature. If it is not at the
appropriate temperature, the timer will delay the cycle to allow automatic water
heating during the main wash.
• When the HI-TEMP wash is selected, an even higher water temperature will be
activated to handle heavier soil loads.
GETTING STARTED
1. Load the dishwasher (see Dish Preparation and Loading sections, pages 14-16).
2. Add detergent (see Filling the Detergent Dispenser, page 17).
3. Add rinse aid (see Filling the Rinse Aid Dispenser, page 17).
4. Select desired CYCLE (see Cycle Chart, page 13).
5. Select desired OPTIONS (see Control Panel, page 10). The indicator light above the
pad will glow when selected.
6. To start, press start/cancel (see Control Panel). Then close door
Note:
Your dishwasher has the controls mounted on the front of the door. The
door must be closed first if you want to operate the appliance.
