22
Step 12: Completing the Installation
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
5. Confirm that the kick plate gasket is on the bottom of the kick plate. To install the
kick plate with screw ST3.9*13, refer to the figure 16.
installing the dishwasher
WARNING
Check if the power turns on correctly and if there is any water
leakage while the dishwasher is operating. If no errors occur while it is
operating, turn off the dishwasher and go to step 5.
If an error has occurred, turn off the dishwasher, close the water
supply valve, and refer to the user manual or contact a service center.
Make sure to check for water leakage on both ends of the water
supply line and drain hose connector.
Figure 16
