20
19
W
ater Supply
INSTALLATION
Direct wiring
1. Remove the junction box cover from the power supply junction box on the wall.
2. Locate the three dishwasher wires, (white, black, and green) with stripped ends,
then insert the dishwasher wires through the small hole in the junction box.
3. Secure the house wiring to the bottom of the junction box with a strain relief
fitting.
4. Use wire nuts to connect incoming ground to green, white to white, and black to
black.
5. Replace the junction box cover. Make sure that no wires are pinched under the
cover.
W
ater Supply
INSTALLATION
STEP 6: INSTALL THE 90° WATER SUPPLY ELBOW
1. Wrap the male thread of the 90° elbow with Teflon thread seal tape twice.
Do not use plumber’s putty.
2. Install the 90° elbow onto the water valve. Do not overtighten the 90° elbow.
The water valve bracket could bend or the water valve fitting could break.
3. Position the end of the elbow to face the floor when the dishwasher is upright.
UP
DOWN
15
Step 6: Install the 90° water supply elbow
1
Wrap the male thread of the 90° elbow with Teflon thread seal tape twice. Do not use plumber's putty.
2
Install the 90° elbow onto the water valve. Do not overtighten the 90° elbow. The water valve bracket could bend or the
water valve fitting could break.
3
Position the end of the elbow to face the floor when the dishwasher is upright.
You’ll need:
Adjustable wrench
90° elbow
Teflon thread
seal tape
YOU’LL NEED
• Adjustable wrench
• 90
°
elbow
• Teflon thread seal tape
