SBTL5000 series User Manual
P a g e
|
6
Figure 2-3a
Mark the screw hole centre of the stand, and the edge of the chassis base on the ground according to
the sizes as shown on the Figure 2-3a. Use a hammer drill to perforate M12 screw holes and then
install the screws. Place the swing barrier turnstile according to the sizes and positions as shown in
the figure before installation and fixing. Connect the online cables and perform the power-on test. If
the test is OK, tighten the screws. It is recommended that a warning line be marked out on the
ground after the machine is installed, so as to prompt the pedestrian to stand behind the warning line
when swiping the card. As shown in Figure 2-3b:
Figure 2-3b
