ZKTeco OP1000 Series, User Manual, Page: 8 / 15

6 OP1000 series User Manual
the ground, with the height of the exposed part not exceeding
100mm
. In addition, the conduit
outlet is bent back to prevent ingress of water into the conduit.
Figure 3-3
3.3 Equipment installation and fixing
Mark the screw hole centre of the stand, and the edge of the chassis base on the ground according to
the size as shown in Figure 3-3. Use a hammer drill to drill M12 screw holes and fix the screws
accordingly. Place the swing barrier turnstile according to the size and position as shown in the figure
before installation and fixing. Connect the online cables and perform the power-on test. Tighten the
screws after the test is passed.
3.4 Set up a warning line
It is recommended to mark a warning line on the ground, as shown in Figure 3-4, after the machine is
installed, so as to instruct the pedestrian to stand behind the warning line during card swiping:
Figure 3-4
120.00
38
0.0
0
600.00
120.00