mTS1000 Series Tripod Turnstile
User Manual
P a g e
| 17
Copyright©2021 ZKTECO CO., LTD. All Rights Reserved.
Buttons
Description
A
Press the button once to open the tripod turnstile on the inbound and can pass by
identity verification from the inbound.
B
Press the button once to open the tripod turnstile on the outbound and can allow
people to pass after their identity verification from the outbound.
C
In emergency mode, press the button once to fall the arm lever. Then the inbound
and outbound sides get open and can pass freely without identity verification.
D
Press the button once to raise the arm lever. Then the inbound and outbound
sides are controlled by the tripod turnstile. The identity verification becomes
invalid, and no pass is allowed.
When the controller is powered on, the wireless remote control is not in communication with the
controller. Press and hold the DIP switch of the controller to enter the code pairing mode and
operate the remote control according to the eight DIP switch codes of the controller.
To code:
1. First, power the controller of the tripod turnstile.
2. Short press the learning button on the controller, and a light corresponding to the button will
flash slowly. Then press any switch on the remote control for acquiring the information. After
the successful operation, the light turns off.
Clear code:
Long press the learning button on the three roller gate controller for 3 seconds. The learning light
stays on for a while then turns off indicating the code is cleared successfully. The original learning
remote control cannot be used again and can only be remote-controlled by the code again.
