5EVM-D · Electric Vehicle Home AC Charging Station
9
M5EVMD2011I
5EVM-D: Electric Vehicle Home AC Charging Station
© ZIV APLICACIONES Y TECNOLOGÍA, S.L.U. 2020
4.3.1
Equipment Power Supply
The power supply is represented in Figure 5 by the connector 1.
The power supply is provided by screw terminals, which offer great mechanical robustness.
These terminals allow cable sections of up to 25mm
2
.
The equipment has the following terminals from left to right:
L1
. Phase R.
L2
. Phase S.
L3
. Phase T.
N
. Neutral.
GND
. Ground.
The number of terminals may vary based on the model of the recharge point, as it can be
single-phase or three-phase.
4.3.2
Vehicle Power Supply
The power supply cables and the IEC62196-2 hose ground, which is connected to the vehicle,
are screwed into the terminals shown in Figure 5 as
connector
2
.
The equipment, depending on the version, has the following terminals from left to right:
GND
. Ground.
L1
.
Phase R.
L2
.
Phase S.
L3
.
Phase T.
N
.
Neutral.
4.3.3
Pilot Wire (CP)
Represented in Figure 5 as
connector 3
.
This terminal block is dedicated to the following:
Connection of the pilot wire (CP) of the hose according to
IEC 62196-2
.
The "Control Pilot" wire is used to regulate the demand of the EV by means of a PWM signal.
4.3.4
Communication of the Recharging Points Network
Represented as
connector 4
in figure 5, two RJ11 connectors are available for RS-485
communication.
4.3.5
USB Port
Connector without assigned functionality.
