FIRMWARE UPDATE (JTAG)
Please check zisworks.com/downlolads for full firmware update instructions via the JTAG
interface.
FIRMWARE UPDATE (SOFTWARE) (NOT IMPLEMENTED
YET)
First, switch to single-input 4k60 mode. Then enable the firmware update flag via the serial
command interface, then open the firmware update image at 100% zoom level and wait. During and
after this process, a message will appear on the screen indicating the status of the update process.
When the firmware update flag has been set, the system will scan the input video stream for
special sequences of bits and write them to the system flash. Once integrity of the entire image has
been verified, the data will be copied from the temporary flash location into the active boot region of
the flash. It is extremely important that the system is not interrupted during this time.
“UHD TCON for Innolux Panels” User Guide ZisWorks.com Page 11/11
