UNPACKING / INSPECTION (CONTINUED)
2.
Unpack the crate and any associated packages. Inspect the contents. Retain packaging materials
until all components have been found. A standard Hot Spot 110 furnace system consists of the
following components:
•
One furnace complete with insulation, controllers, heating elements and door in place.
•
One owner’s manual.
•
One power cord.
•
One alumina insulation setter plate.
•
One box of Precision Temperature Contorl Rings (PTCR) with temperature chart.
3.
Place the furnace on a sturdy, level table near an electrical outlet appropriate for the Hot Spot
110 ordered.
4.
Remove the packing material from under the roof and in the heating chamber.
•
Remove the roof cover by unscrewing the bolts at the rear of the unit and the front bezel.
Remove the foam packing material. Replace the roof cover (see appendix A #6, 9, 10).
•
Open the Hot Spot 110 door by turning the handle and lifting outwards and upwards until it
catches on the latch (see appendix A #7). Remove the packing material from the heating
chamber. Be careful not to touch the heating elements.
IMPORTANT! - ALL PACKING MATERIAL MUST BE REMOVED
BEFORE PROCEEDING!
3.
Inspect the furnace interior, heating elements and door for damage.
4. INSTALLATION / ASSEMBLY
1.
With the furnace door open, install the setter plate by carefully placing it onto the floor of the
furnace centered between the elements.
2.
Close the door using two hands. Lift the door up and back with one hand, disengage the
hold up latch with the other hand and gently guide the door down into the closed position.
The safety cut off switch located on the lower right side of the control panel (see appendix A #8)
will audibly click into place.
3. Plug the female end of the power cord into the power cord receptacle on the back of the furnace
(see apendix A #12).
4. Plug the male end of the power cord into an appropriate wall outlet.
5.
Congratulations! Your Hot Spot 110 is ready to be powered up.
4
R-110M-01 Rev00
