MK-100301 EU_EN_Rev. 6.0 - US Rev. F
20
ENGLISH
ENGLISH
Insert or remove the Grab Handle:
Always stabilize the mobility device before performing the action.
• Rotate the front casters until they point forward.
• Engage the parking brake.
1. Be careful to avoid pulling or crimping any life support tubing that may be
attached to the child. This adjustment can create a pinch point, so be careful to
remove any obstruction, and/or clothing that could get stuck in this area.
2. The adjustment is made from the front of the device. Depress both detent pins (E)
simultaneously, and either insert or remove the Grab handle (D).
3. If you are inserting the Grab Handle (D) push the handle in far enough so that the
detent pins pop out of the locking hole (E).
4. Pull up on the handle to make sure that it is locked into place.
5. Depending on preference, the grab bar is reversible.
G. TILT IN SPACE ANGLE ADJUSTMENT
WARNING
BEFORE using the tilt adjustment, always check that the mobility device is completely
unfolded and in the locked position, and that all four wheels are locked in place. Be
careful to avoid pulling or crimping any life support tubing that may be attached to the
child. Always remember to stabilize the mobility device before performing this action.
• Rotate the front casters until they point forward.
• Engage the parking brake.
Tilt adjustment:
16
1. Remove the safety pin to allow tilt. Grasp the tilt lever (A) on the left side of
the frame, and squeeze, and then pull back on top of the seating shell to achieve
desired angle adjustment. The back support and seating support components,
including the footrest should move together.
2. Release the handle and gently pull on the seating shell to make sure it is locked in the
new position.
3. This adjustment can change the balance of the device slightly so it is good to check
that there is no danger of tipping with the new setting
VIII. SET–UP & USE
15c
16
A
15c
D
E
