TROUBLESHOOTING
22
ZI-PS330 & ZI-PS1000
12.3
Storage
If you store the product for more than 1 month, charge it fully before storage and charge it about
every 3 months to avoid complete discharge and possible damage.
Store indoors, at cool temperatures, mild humidity and away from direct sunlight.
Storage in a vehicle or other enclosed space in extremely hot temperatures may result in shortened
life, overheating and fire. Extreme cold below the specific storage range may also affect the perfor-
mance and life of the product. Keep the unit away from corrosive chemicals and gases. After re-
moval from storage, visually inspect the product and all accessories to ensure that they look satisfac-
tory. This will increase the check you the side intake and exhaust ports to ensure they are free of de-
bris. Allow the Product to readjust to ambient conditions before recharging it or charging other
equipment.
12.4
Disposal
Observe the national waste disposal regulations. Never dispose of the product, product
components or operating equipment in the residual waste. If necessary, contact your local
authorities for information regarding available disposal options.
If you purchase a new product or equivalent equipment from your specialist dealer, he is
obliged in certain countries to dispose of your old product properly.
13
TROUBLESHOOTING
WARNIN G
Danger due to electrical voltage!
Manipulation on the product by existing battery capacity can lead to serious injury or
death!
Failure
Possible cause / correction
The product can neither charge
nor operate connected devices
•
Ensure that the DC/USB/AC outputs are enabled by pressing the A & C/D/E
button(s) for the port(s) being used.
•
Ensure that the connected device is suitable for the product by checking
the output specifications in the technical data.
•
Make sure the product is charged by checking the battery level indicator on
the display.
•
Check the wattage numbers shown on the display status indicator for over-
load.
The product cannot be charged
•
Make sure that the cable of the plug-in power supply is fully plugged into
the DC input.
•
Make sure that the power adapter is the charger supplied with the product.
If the input does not meet the requirements in the technical data, the "Low
Watt range 0% to 10%" display may appear.
•
If the device cannot be charged immediately after discharging, please wait
for one hour and try again, as it may go into over-temperature protection.
