DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-HS8TN
Change the hydraulic oil:
•
Remove the oil drain plug to drain the oil from the hydraulic
system.
•
Use a drip pan to collect waste oil and particles.
•
Inspect the oil for metal chips. (Metal chips in the oil are an
indication of increased wear.)
•
After the oil has been completely drained from the machine,
reinstall the drain plug.
•
Top up the recommended fresh hydraulic oil via the oil filler
plug.
•
After changing the oil, actuate the wood splitter several times
without actually splitting any wood.
•
Use a dipstick to check the oil level.
17.5
Sharpening Wedge
This log splitter is equipped with reinforced splitting wedge which blade is specially treated. After long
periods of operation, and when required, sharpen the wedge using a fine toothed file removing any burrs or
flat spots on the edge.
18
DISPOSAL
Observe the national waste disposal regulations. Never dispose of the machine, machine
components or equipment in residual waste. If necessary, contact your local authorities for
information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer, he is obliged
in certain countries to dispose of your old machine properly.
19
TROUBLESHOOTING
WARNING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to the
mains. If you are unable to carry out necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
PROBLEM
PROBABLE CAUSE
REMEDY SUGGESTED
Motor does not start
•
Switch is Off
•
Set switch to On
Incorrect motor rotation
direction
•
Incorrect connection
•
Use the phase inverter to
change the polarity of one of
the phases on the motor.
Log Splitter does not work
while motor running
•
Valve is not opened owing to
the connection parts loosening
•
Check and tighten the parts
•
Control Levers or connection
parts bent
•
Repair the bent parts
•
Lower hydraulic oil level
•
Check and refill hydraulic oil
Log Splitter works with
abnormal vibration and
noise
•
Lower hydraulic oil level
•
Check and refill hydraulic oil
