CLEANING, MAINTENANCE, STORAGE, DISPOSAL
36
ZI-GPS252
Sawing in sections:
•
Trim long or thick branches before you
make the final cut
Safe working position
14
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
WARN IN G
Before carrying out any maintenance work, ensure that moving parts are stationary, that
the machine is disconnected from the mains supply and / or that the PTO shaft is uncou-
pled.
14.1
Cleaning
N OTE
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents, nitro
thinners, or other cleaning agents that could damage the machine's paint. Observe the
information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life. Therefore,
clean the machine after each use and remove any dust and other deposits with a cloth or a brush.
NOTE:
The use of solvents, aggressive chemicals or scouring agents can cause damage to the plastic parts
of the machine!
Thus, when cleaning, use only water and, if necessary, mild detergents.
14.2
Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless, malfunctions or
defects which could impair the safety of the user must be rectified immediately!
•
Before each operation, check that the safety devices are in perfect condition.
•
Regularly check that the warning and safety labels on the machine are in perfect and legible
condition.
•
Use only proper and suitable tools.
•
Only use original spare parts recommended by the manufacturer.
14.2.1
Inspection and maintenance plan
The type and degree of product wear depends to a large extent on the operating conditions. The following
intervals apply when the product is used within the specified limits:
intervall
components
activity
Before usage or after any
maintenance or servicing
screws, nuts
check for loose or missing bolts and nuts.
cutting elements
check for damage and tight fit (tension)
tank system
check for damage and replace if necessary
