Zipper Mowers 9120039238371, User Manual

Page: 36 / 100

ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  36
ZI-FKS315
14 ASSEMBLY
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
14.1 Assembly
14.1.1 Setting up the machine (Fig. 3-8)
Place the table saw with the table touching the floor on a flat floor. Fix the four legs 18 in the
inside of the main body with four screws (SW13) for every leg (Fig. 3). When you insert the legs
you have to look that they are exactly in the related curbs. Mount the four rubber feet
25 on the
legs (Fig. 8). Fix the wheels 15 on the legs at the inside with two screws for every leg. The four
spacers 26 must be inserted between the legs and the angle bracket 22 (Fig. 4). When
assembling, make sure that the rounded side of the angle bracket faces the bottom of the
machine. Turn the saw upside down and place it on the floor. Now insert the sliding table
3
carefully into the slide ways 24 and push the sliding table to the point where the locking hook
latches 10 (Fig. 5) home. Now screw the mount for the extractor hose 29 and the tool hook 28
on the main body of the machine 1 (Fig. 6, 7).
14.1.2 Fitting and removing oft he saw blade guard (Fig. 9)
Mount the blade guard 2 on the splitter 5 , so that the screw 37 fits through the hole 45 . Don’t
tighten the screw too tight - the saw blade guard has to be able to be moved freely. Fit the
extractor hole 13 on the extractor adapter 14 and the extractor socket of the blade guard 2 .
Important: The blade guard has to be lowered over the work piece before cutting.
14.1.3 Dismantling the sliding table and opening the chip box (Fig. 12, 13)
Pull the sliding table 3 back till you can see the locking hook 10 . Press down on the locking hook
10 with one hand and at the same time use the other hand to pull the sliding table forward and
out of the guide 24 (Fig. 12). Now remove the two screws b (Fig. 13) and flip open the chip box.
Tip: The screws are removed easier if there will be adjusted an angle of about 45°. For the fitting
you have to do these steps backwards.
14.1.4 Mounting the table extension
Mount the table extension like shown on the below pictures.