OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
16
ZI-COM50-10
14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
14.1
Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
N O T I C E
The machine should be set up near the working consumer. Avoid long air lines
and long supply lines (extensions).
Make sure the intake air is dry and dust-free.
Do not set up the machine in damp or wet areas.
The machine must be operated on firm, level ground
When removing the hose coupling, hold the coupling piece of the hose is by
hand. So the injury from rebounding hose is avoided
14.2
Operation
Switch on:
Push the ON-OFF-switch “1”
Switch off:
Push the ON-OFF-switch “0”
Setting output pressure:
The output pressure can be set with the pressure regulator
Output pressure:
The output pressure is shown on the manometer output pressure
Pressure switch adjustin:
The pressure switch is set at the factory.
Starting pressure ca. 8 bar
Stoping pressure ca. 10 bar
Before use, check whether the compressor switches off when the switch-off pressure is reached.
Afterwards, check the pressure of the compressed air by means of a compressed air tool to ensure that
the compressor starts up again when the pressure is reduced
Output:
Only perform in a pressure-free state
To connect a device place the union joint into the coupling. The sleeve will go to starting position
automatically. To disconnect pull the sleeve backwards and remove the hose.
