CLEANING, MAINTENANCE, STORGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
51
ZI-BAS205 / ZI-BAS250
51
18
CLEANING, MAINTENANCE, STORGE, DISPOSAL
WARNING
Handling the machine with the power supply on, may lead to serious injuries or even
death. Always disconnect the machine from the power supply before cleaning,
servicing or maintenance work and secure it against unintentional reconnection!
Cleaning
CAUTION
Never clean the band saw blade or the band saw rollers with a brush held in the
hand or with a scraper while the machine is running. Always wait until the machine
has come to a complete standstill!
NOTE
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Subsequently, regular cleaning is a prerequisite for the safe operation of the machine and its
long service life. Therefore, clean the device after each use of chips and dirt particles.
Maintenance
WARNING
Danger due to electrical voltage! Handling the machine with the power supply
up may result in serious injury or death. Always disconnect the machine from the
power supply before servicing or maintenance work and secure it against
unintentional restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Intervall
Component
Measure
Before operating the
machine
Safety devices
Check the condition
Nuts, Bolts
Check if securely tightened
Drive belt
Check the condition. If necessary tension it.
Saw band
Check the condition. If necessary replace it.
After every use of the
machine
Machine
Clean the machine from chips and sawdust.
Wheel housings
Vacuum off chips and sawdust
Saw band guide
Lubricate the saw blade guide slightly with acid-
free lubricating oil
Thrust bearing
Guide discs
Keep guide discs and the thrust bearing free
from deposits
Saw band
Slacken the saw blade
Monthly
Drive belt
Check the condition. If necessary replace it.
Security stickers
Check the condition. If necessary replace them.
Table insert
Check the condition. If necessary replace it.
Thrust bearing
Guide discs
Check the condition and replace them replace if
they are worn out.
