ZIPPER MASCHINEN 9120039232737, User Manual

Page: 28 / 78

OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  28
ZI-KS210
14 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
14.1 Operation instructions
W A R N I N G
Perform all machine settings with the machine being disconnected
from the power supply!
N O T I C E
 Do not use damaged or warped saw blades.
 Replace the worn table insert.
 Select the appropriate saw blade for the material to be cut.
 Warning! Protective equipment must not use for the purpose of transport
 Use the saw only if the safety devices are functional, in good condition and in the
provided position.
 Do not remove offcuts or other workpiece parts from the sectional area, as long as
the machine with unprotected blade is moving.
 The workpiece must always be clamped to the saw table.
 Before each cutting operation make sure that the machine stands safely.
 Mark the cutting line on the workpiece.
 Set the angle of the cutting operation.
 To make a cut from the workpiece hold the laser along the marked line.
 Remove the workpiece only after the cut has been completed
14.2 Operation
Cutting head:
Raising:
Push down slightly on the Handle and pull
out the stop latch knob (1).
Allow the cutting head to rise to the up
position.
Locking:
Push the cutting head down to its lowest
position.
Push the stop latch knob into the locking
hole.
Horizontal swing:
The interlocks on the machine table are at
angles of 0, 15°, 22,5°, 30° and 45° in
both directions.
If you require a different angle, secure the
saw by tightening the handle (1).