OPERATION
Z.I.P.P.E.R Maschinen GmbH
www.Zipper-maschinen.at
Seite29
ZI-GHAS2800
14.6
Tips
A T T E N T I O N
Always wait for the rest of the chaff, before turning it on again.
Longer material that protrudes out of the machine could turn out if it is confiscated by
the chopper blades
1.
Longer material that protrudes out of the machine could turn out if it is confiscated by
chopping!
2.
Keep at a safe distance!
3.
Caution! Always use the slide when you try to push the material into the feed tube. Make
this never directly with your hands! Insert the slide after use back to its original position.
4.
Heavy material or branches lead to blocking of the chopper blade when they are chopped
through.
5.
Fill out the material to be chopped from the right corner of the hopper a forth.
6.
Examine the material to be chopped carefully. Make sure that it is not in contact with
stones or nails, as these could damage the shredder heavy.
7.
Check for signs of vibration. Strong vibrations caused by damaged or worn blades. Replace
the blade if necessary.
Large objects or pieces of wood may be removed by the material removed is changed and
the same between the cutting and release direction of the chopper blade.
Perform only so much material that the feed tube is not clogged.
You chopping garden waste that has been stored for several days and are wilted and
moist, alternating with tree branches.
This avoids that the chopping blades is blocked.
Do not put soft material such as kitchen scraps into the chopper, but compost it.
Widespread material with leaves must first be completely shredded before new material is
introduced.
Make sure that the shredded material is free to fall out of the chute
–
there is the risk of
back!
The ventilation slots must not be covered by the collector or chopped
14.7
Adjust buffle
The best distance between baffle
②
and the cutting blades
①
is 0 from
0,50 mm. This distance should be
adhered to in order to achieve suc-
cessful work.
There is an adjustment on the right
side of the plastic case. To adjust
the distance, turn the knob
③
clockwise, so that the bolt is to-
wards blade rotates. With a half
circle, the panel moved 0.50 mm
toward cutter. Perform after adjust-
ing cutting tests to check whether
the best result is achieved. Make
sure that the blade does not strike against the panel to prevent damage to the appliance.
Autogoods “130”
130.com.ua
