OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
22
ZI-BG100Y
15.2.2
Checking the fuel tank level
N O T I C E
Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
1.
Screw on the tank cap (sits on the fuel tank).
2.
Level check in the form of a visual inspection. If necessary, top up with fuel
with the appropriate octane number (RON 95).
3.
Close the fuel filler cap tightly after refuelling.
15.2.3
Checking the gear box oil level
16
OPERATION
Save the working environment before you start working.
Only put the machine into operation after you have read and understood the safety
instructions and carried out the necessary measures before initial commissioning.
Proper preparation and consistency of the concrete are essential for a good working.
Transport of the machine onto the concrete to be processed: Mount the transport bar
into the bar holder at the front side of the machine. Minimum two persons lift the
machine onto the concrete surface. Attention! The machine is heavy. Be sure to
proper lifting technique to avoid injuries.
Information on Initial Start-up
N O T I C E
Note that the machine is delivered without engine oil and fuel. Make sure that
this equipment is filled up before the machine is put into operation for the first time.
ATTENTION: The machine does not start until the engine oil has been refilled to
the upper limit.
16.1.1
Test Run Initial Start-up
Let the machine run idle for about 3 minutes.
Pay attention to abnormal noises.
Pay attention to the exhaust fumes (too black, too white)?
16.1.2
Notes on the first 20 operating hours
In order to optimize the life expectancy of your machine, the following points should be observed:
Do not operate the engine for the first 20 operating hours @ maximum load (this also
applies to used engines after extensive maintenance). This means lower speed and lower
maximum working load than during normal operation.
Change the engine oil after the first 20 hours of operation.
Operating Instructions
Never use the recoil-starter while the engine is running. This will damage the engine.
The pull mechanism for changing the engine speed is limited by an adjusting screw. This is
factory set. Never change this setting on your own, you could overload the motor.
Do not operate the machine on slopes of more than 20°, as even with an optimum oil level
the engine may not be supplied with sufficient lubrication.
In the direction of the machine and within a range of one meter around the vibrator,
nobody but the operator must stand.
If the machine is working in an environment e.g. on soft or uneven ground, make sure to
reduce the horsepower to the lowest level to prevent the machine from sinking. On slopes
(max. 20° allowed!!!), make sure that the machine does not tilt.
