P R O V E E
42
Final assembly
Put the boat on your stand. This is where it will live,
when it’s not in the water.
Install everything. It may be necessary to clean out
paint from some of the holes.
Install the aluminum pushrod seal mounts through
the radio box and stretch on the rubber seals.
Push the threaded end of the rudder and throttle
pushrods through the big end of the pushrod seals.
Attach both ends of the pushrods, making sure the
seals are on the outside of the radio box.
Setup
Adjust the stinger so that it is parallel and flat with
the bottom of the boat. This will be a zero setting.
Use a straightedge ruler.
Adjust your trim tabs so that they are parallel with
the bottom of the boat. Not angled up or down.
This is a zero setting.
Get them as close to the bottom as you can, without
being below the bottom.
Use a square to adjust the turn fin. It must be
perfectly square (90 degrees) to the bottom.
Do the same for the rudder. You can square the
rudder bracket to the top of the transom.
