Instructions. V1.01
Page 9
October / 2013
1. Check the incoming water supply pressure with reference to the table and diagrams on
the following page to determine the layout required bearing in mind that mains water
supply pressure can increase considerably at night.
2. Refer to the diagrams in (fig.2) to determine the accessories required to suit your layout
3. Position the heater and controls to allow for future maintenance.
4. All control and safety valves are marked with the direction of flow and will not function if
incorrectly orientated. Do not break any seals or attempt to adjust any safety valve, to do
so may impair the safety of the installation and will invalidate the warranty.
5. To ensure a watertight seal use fibre washers for connecting the inlet and outlet pipes to
the heater. Complete the seal by using PTFE tape to the threads but do not over apply or
extend beyond the thread limits as this will lessen the effectiveness of the joints. Do not
use plumbers paste to secure the joints as this can impair the operation of any valves
connected to the heater.
6. An isolating service valve (not supplied) should be fitted in the cold water supply pipe
work as shown in all 3 diagrams in (fig.2).
7. Flush all pipe work thoroughly before making the final connections to the valves,
accessories and cold feed to the heater to ensure that any debris is removed. Failure to
do this may result in irreparable damage to the controls and will invalidate the warranty.
Plumbing and safety control arrangement
The unit will be supported by being hung on a bracket fixed to a support wall, as
shown (fig.1). Therefore it is important to ensure that the wall is strong and solid
enough to fully support the unit when the tank is full.
It is important to ensure when drilling the wall, that the selected position avoids any
pipe work or electrical cabling. To mount the heater, the bracket ‘hooks’ locate into
the slots provided in the back of the unit, allowing the unit to hang flat against the
wall.
IT IS NOT NECESSARY TO REMOVE THE CASING TO MOUNT
THE WATER HEATER ON THE WALL BRACKET.
