Page 18 of 20
Zip HydroTap Installation and Operating Instructions - 82872 - July 2003
If you do NOT wish to programme the timer to turn the Zip HydroTap on and
off daily, you may ignore the following instructions.
The Zip HydroTap will operate continuously if you do not programme the
timer at all.
If you do wish to programme the timer to turn the Zip HydroTap on and off
daily, first set the timer to the correct time, then follow the instructions set
out below. You can programme the timer to turn the Zip HydroTap on and
off up to 3 times daily.
Setting Correct Time
Hold down the
button until the following 3 steps are completed.
1.
Change day:
With
button held down, press button “d”.
A triangle points to day currently selected.
Days are marked 1 to 7.
Day 1 = Monday, Day 7 = Sunday.
Press and release button “d” until correct day is selected.
2.
Change hour:
With
button held down, press button “h”.
Screen shows hour currently selected.
Clock works on 24 hour time: 1 = 1 am, 13 = 1 pm.
Press and release button “h” until correct hour is selected.
3.
Change minute:
With
button held down, press button “m”.
Screen shows minute currently selected.
Press and release button “m” until correct minute is selected.
When, day, hour and minute are correct, release
button.
Programming Power ON & OFF
1.
Press and release the “Prog” button once.
2.
Display will show first setting: (—:— 1 ON).
3.
Triangle over “1” indicates setting for Monday.
4.
Press and release “h” and “m” buttons to set ON time.
5.
Press and release the “Prog” button once.
6.
Display will show second setting: (—:— OFF).
7.
Triangle over “1” indicates setting for Monday.
8.
Press and release “h” and “m” buttons to set OFF time.
9.
Press and release “Prog” button once.
Repeat procedure to set further Monday ON and OFF times.
Or press and release “d” to go directly to first setting next day.
Programme ON and OFF for each day of week.
When complete, press and release
button.
During programming a 40 second delay will return you to clock display.
To return to programming point, press “Prog” and “d” buttons together.
To review programme, press and release “Prog” repeatedly.
To erase any ON or OFF setting displayed, press “h” and “m” together.
For total reset, press “d”,
, “m” and
buttons together.
To over-ride OFF setting, press and release
button – will remain ON
until the next programmed OFF time.
To lock timer ON or OFF press “m” and
buttons together. Check
screen: black dot over ON or OFF indicates timer locked.
Setting the Energy Saver Timer
prog.
m
h
d
