Page 5 of 24
HydroTap Installation and Operating Instructions_Commercial_BCH 4in1_BH 3in1_October 2012_V1.05
Read These Warnings First
Zip Hydrotap undersink assembly.
The appliance must be placed in a horizontal,
upright position, as shown above.
BCH Unit
BH Unit
Note:
Always ensure the tubes are
shortened so that any excess
is removed and their route is
the most direct line between
the tap assembly and the
HydroTap unit.
Do not allow the tubes to sag
or droop so water is trapped
within the hoses. Always
maintain a constant fall
Positioning of the tap assembly
must be within the following
parameters:
The height between the base of
the Hydrotap unit and the base
of the Tap assembly cannot be
greater than 900mm.
Safety
This appliance is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.
Refrigerant
The Zip HydroTap Chilling unit contains 134a refrigerant under pressure. No part
of the unit should be exposed to a naked flame. Maintenance of the refrigeration
unit must be carried out by an accredited service provider or qualified refrigeration
mechanic.
Qualifications
If the power cable is damaged it must be repaired only by a qualified technician. To
avoid hazards, all installation procedures must be carried out by a suitably qualified
tradesperson. The power cable and power outlet must be in a safe visible position for
connection.
The power supply cable must be adequately secured.
Do not remove the cover of the appliance under any circumstances without first
isolating the appliance from the power supply.
As the installer, it is your responsibility to supply (if necessary) and install all valves as
required by local regulations and relevant standards.
The plumbing installation must be done in accordance with local Water Authority
regulations and these Installation Instructions.
This appliance must be earthed.
Venting
Sometimes steam and / or boiling water may discharge through a vent outlet at the
mouth of the tap. If the tap is not installed using the Font pedestal, ensure the tap
body is located so the tap outlet safely drains into the sink bowl area.
NOTE:
On startup, the controls take the system through a calibration process which
causes the unit to over-boil for a period of 90 seconds. Once this mode is completed
the system reverts back to normal operation.
Lifting
Take care when lifting the Zip HydroTap undersink unit. Some units may exceed safe
lifting guidelines. If you feel this is beyond your personal capabilities, please seek
assistance with the lift. The weights of the units are marked on the packaging and are
given in the table on page 7. Do not lift the unit by the doors.
Airflow
The ambient temperatures this unit should operate within are 5ºC - 35ºC.
Proper air circulation must be provided. The system will operate satisfactorily only
if the recommended air gaps are provided, these are 65mm min rear clearance
and 50mm side clearance. An air vent is provided with each unit for high usage
applications, this must be installed in the top half of the cupboard door as a matter of
course. An accessory exhaust fan kit is available and when supplied should always
be fitted to ensure adequate ventilation. Make sure that the ventilation grilles of the
undersink unit are not obstructed.
I
ncluded in the installation pack are adhesive
backed silicon buffers. If air vents are not installed in the cupboards housing the
HydroTap, the buffers must be placed on the inside edge of the cupboard door to
create a slight gap ensuring a minimum airflow. Failure to do this may cause the
HydroTap to overheat and operate inefficiently.
Front View
Side View
Side View
Front View
