13
Installation instructions & user manual
806310UK V1.00 July 2019 - HydroChill HC05
Technical support
Tel: 0345 6 005 005 Email: [email protected] www.zipwater.co.uk
Insert filter
Rotate
Insert
Filter replacement
Remove filter
Rotate
Pull
• For safe operation, the filter cartridge should be replaced at least every 6 months,
or earlier if you notice a persistent reduction in water pressure from the tap or an
unpleasant taste or odour in the water.
• For safe operation, thoroughly flush the water through after periods of non-use
longer than 12 hours.
• Not changing the filter cartridges when required may cause the water to become
biologically unsafe.
• Use only a Zip filter to match the one used in your chiller product (see Spare parts
page 5). The filter cartridge can be obtained directly from Zip, visit www. zipwater.
co.uk or alternatively call Zip on 0345 6 005 005.
The filter is located behind the front access panel on the HydroChill. The installation
date should be written on the filter cartridge. No special tools or skills are required
to install the filter cartridge.
• Disconnect the mains electricity supply.
• Unscrew the front panel (2 screws at bottom of panel) & lift out to locate the filter.
• Grasp the filter cartridge firmly and twist it horizontally a quarter turn clockwise until
it stops.
Some water will drip from the filter head during the replacement process so it is a
good idea to have a bucket and cloth handy to catch and mop up any spills.
• Ensure that the electrical connections do not get wet.
• Gently ease the cartridge downwards to detach it from the filter head, then pull it out
and discard responsibly. Take care not to tip it up once free as water may spill out.
• Write the date of replacement on the new filter cartridge label.
• Remove the protective plastic cap. Insertion method is opposite to removal.
• Align the tabs of the replacement cartridge with the filter head and insert it up into
the filter head.
• Turn the replacement cartridge a quarter turn anti-clockwise until it stops and locks
into position.
• When the filter replacement has been completed, purge the system of trapped air by
dispense water from the tap until it flows without any further spluttering. Run 10 litres
of water through the system to complete the purge.
• Refit the front panel, clean the stainless steel surfaces, wipe dry any water spills.
• Reconnect the mains electricity supply, & wait for the water to cool before drinking.
!
!
