DEX & DBX Installation, Maintenance and User Instructions V1.05
Page 2
August / 2014
Safety Information
WARNING
• Installation, commissioning and maintenance of this appliance must only be carried
out by a competent installer who will then be responsible for adhering to all relevant
standards and regulations.
• The front cover of the appliance must never be opened before disconnecting the appliance
from the mains power supply.
•
To protect the appliance, a circuit breaker or fuse must be fitted with a rating suitable for the
nomi nal current of the appliance.
• The appliance must be permanently connected to the supply through an isolating switch with a
contact separation of at least 3mm in all poles and be protected by a suitably rated RCD.
• The cross sectional area of the connection cable must be appropriate for the power rating and
location of the appliance. See Technical Data.
• The connecting cable must be adequately secured.
•
This appliance must be earthed at all times.
• Check that the power supply is switched off prior to electrical connection.
•
The appliance, its wiring and piping must not be modified in any way.
• In case of malfunction isolate the power supply immediately. In case of leaks also isolate the
water supply. Repairs must only be carried out by Zip Heaters (UK) Ltd or an authorised Zip
service engineer.
• Temperatures in excess of approximately 43°C are perceived as hot, especially by children, and
may cause a feeling of burning.
• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning the use of the appliance in a safe way
and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
•
When the appliance has been in use for some time, the fittings may be very hot.
• If inlet temperature is up to 70°C (eg. fed from a solar supply) mixing with cold water will be
required to ensure a safe temperature at the outlet.
