Zip ChillTap - Installation & Operating Instructions - CT1/140 - June 2013 v1.01
Page 4 of 8
Installing the Chiller
Site the chiller unit in the cupboard as close to the proposed outlet tap position
as is possible to minimise the length of tubing exposed between the chiller unit
and the outlet tap.
Allow at least 50mm around the chiller unit to permit free airflow. Both the top
and the front of the chiller must remain accessible for servicing purposes.
Installing the Tap
• Position and install the tap at the back of the sink where there is a 45mm
wide flat area within the draining area of the sink.
• Make sure the selected position allows the tap spout to overhang the sink
bowl.
• Use a 25mm sheet metal punch to create a neat hole without burrs.
• Remove the nut and washer from the base of the tap, leaving the rubber
sealing ring in place.
• Fit the tap and seal to the sink, oriented so that the operating lever is
away from the sink bowl.
• Slide the washer and nut over the tubes from under the sink, and tighten
the nut to secure the tap firmly into place.
Install the Filtration Unit
The filtration unit should be mounted as close as possible to the front of the
cupboard, to allow for ready and easy access during filter changes. Usually
the side of the cupboard, near the door, is most suitable.
• Using the two screws provided, screw the filter head to the inside of
the cupboard, allowing 260mm minimum between the underside of the
filtration head and any obstructions like shelves, etc.
• Write the installation date on the filter cartridge. Fit the cartridge into
the housing. The model you have may appear slightly different to that
illustrated, however, operation and function is identical.
• Align the tabs of the cartridge with the filter housing and insert it into the
socket. Turn the cartridge a quarter turn to the right until it stops and
locks into position.
• Check that the direction of flow on the filter head is correct.
Installation Instructions
John Guest connections
Cut tubing squarely with a sharp knife
or tube cutter. Shake out and remove
any swarf and debris.
