Zing PA5520 Zing MPS, Assembly Manual, Page: 10 / 20

19A. If the black molded tray was ordered,
insert the two tray arms into the tray bracket
as shown.
19B. Flip the gray plunger back into the
locked position and tighten knob securely.
21A.There are two screw knobs in the parts
bag. Turn the screw knobs slightly into the
tray bracket on the unit.
21B. Loosen the adjustment knob under
the tray, extend the tray and place the tray
bracket into the base. Tighten securely.
Note: Make sure washer is in place.
21A 21B
19B 19A
22A. Remove 4 bolts from bottom of the
tray, set bolts aside.
22B. Place tray onto bracket as shown.
22A 22B
Washer
MPS, Supine or Tilt Table
MPS, Supine or Tilt Table
Prone
Page 7
20A. If the swing-away tray was
ordered, remove the nut from the bolt on the
tray arm and discard the nut. Make sure all
other hardware stays on the bolt.
20B. Place the ratchet handle onto the bolt
and tighten securely. Repeat steps for the
other side.
20B 20A