10 | Installation Instructions
Précautions de sécurité
DANGER : RISQUE DE CHOC ÉLECTRIQUE, D'EXPLOSION OU D'ÉCLAT D'ARC ÉLECTRIQUE
Ce produit doit être installé par un personnel qualifié conformément aux exigences définies ci-dessous. L'armoire
de batterie doit être installée conformément aux règlements locaux et nationaux. Installez l'armoire de batterie
selon les normes suivantes (en fonction de votre région) :
•
Code national de l'électricité NFPA 70
•
Code canadien de l'électricité CSA C22.1
L'armoire de batterie doit être installée dans une zone à température contrôlée exempte de contaminants
conducteurs. Installez sur une surface plane, solide (par exemple, support en béton ou au sol) capable de supporter
le poids du système.
Suivez toutes les précautions de sécurité lorsque vous travaillez sur le système et portez toujours l'équipement de
sécurité approprié, notamment une protection oculaire.
Avis :
Pour limiter la dérive de l'état de charge lors d'un entreposage de longue durée, il ne faut pas entreposer les
batteries plus de six mois sans les recharger.
Si relié à une ASI qui reste inerte pendant une période prolongée, ZincFive vous recommande d'alimenter l'ASI
tous les six mois pendant une période de 12 heures afin de recharger les batteries.
HAUTE TENSION :
La tension d'armoire de batteries varie selon le modèle entre 370 V c.c et 596 V c.c.
VALEUR ASSIGNÉE DE RUPTURE MAXIMALE (DISJONCTEUR) :
50 kA (déclenchement instantané < 10 mS pour tout
courant >=7 800 A)
DÉTAILS DE L'ÉCLAT D'ARC ÉLECTRIQUE :
Énergie incidente à : 18 po, Valeur assignée d'arc minimale : 20 cal/cm2,
Limite d'arc électrique : 72,5 po
TENUE MAXIMALE AU COURT-CIRCUIT (BATTERIE) :
5 400 A
Outils
Utilisez des outils isolés pour toute tâche d'installation et d'entretien. Les batteries et tous les boulons sont préserrés et
marqués. Outils nécessaires pour l'installation finale :
•
Un tournevis à tête plate isolé : Pour installer les fils c.a. au bornier.
•
Embout de tournevis hexagonal isolé 8 mm ou 5/16 po pour le raccordement du disjoncteur c.c.
•
Tournevis cruciforme no 2 long et court.
•
Clé dynamométrique isolée avec douille de 10 mm : Pour les boulons de batterie.
Summary of Contents for BC Series
