ZIMO MX1, Instruction Manual

Page: 25 / 32

COMMAND STATION MX1, MX1HS, MX1EC Page 25
Read the track occupancy status and loco numbers of a main section
Header byte Value Description
1 0-255 unique sequence-ID
2 0x15 MX9 control instruction
3 4 read the occupancy state and loco numbers of the section
4 MX9_ID MX9 address (1-63 not 901-963)
5 section main section number
Reply: Ack (level 1) see also
4.19
Set new speed limits of a main track section
Header byte Value Description
1 0-255 unique sequence-ID
2 0x15 MX9 control instruction
3 5 set new speed limits to the section
4 MX9_ID MX9 address (1-63 not 901-963)
5 section main section number
6 Limit speed limit
(H=0, U=1, L=2, F=3, A=4, HU=5, UL=6, LF=7)
7 Limit2 optional: apply speed limit when reaching section A (bit 7=1) or
section B (bit 7=0); there is no speed limit change when reaching
the second section if this value is omitted
Reply: Ack (level 1)
Set LED-outputs of a track section module
Header byte Value Description
1 0-255 unique sequence-ID
2 0x15 MX9 control instruction
3 6 set LED-outputs
4 MX9_ID MX9 address (1-63 not 901-963)
5 cGreen settings for „green-LED’s“ on connector “signals”
6 cRed settings for „red-LED’s“ on connector “signals”
7 cLedsA optional: settings for „LED’s-A“ on connector “occupancy indica-
tors”
8 cLedsB settings for „LED’s-B“ on connector “occupancy indicators”
Attention: after sending a message including the optional settings
for the leds on connector “occupancy indicators”, these outputs are
no longer controlled automatically by the MX9 and do not repre-
sent the occupancy status!
Reply: Ack (level 1)
Read/set a MX9-CV
Header byte Value Description
1 0-255 unique sequence-ID
2 0x15 MX9 control instruction
3 7 read/set a MX9-CV
4 MX9_ID MX9 address (1-63 not 901-963)
5 variable Configuration variable that shall be read/set
6 value optional: if a value is present it will be set as new CV-value
Reply: Ack (level 1), Ack (level 2)