Default settings
7
Page 12
Phase setting
(in auto mode)
Pressing the phase setting button opens the selection window in which phases can
be defined.
The settings defined during the previous session are displayed.
The process of constructing and setting the first phase is explained below.
The other two phases are constructed in a similar way.
(1) Pulse mode
The vacuum can be selected as unpulsed or at 3 different pulse rates.
The pulse rate selected is shown in orange.
(2) Temperature
The temperature emitted by the applicator can be set to between -10°C and 5°C.
Press the arrows to increase or decrease the temperature.
(3) Treatment time
Press the arrows to set the treatment time.
Note:
The maximum treatment time is 60 minutes. This takes account of the treatment
times of the individual phases.
(4) Reset
Press the button to reject the parameters selected. The preset values are then
displayed.
(5) Save
The parameters selected are accepted for the treatment.
Note:
The parameters selected that have been saved are retained after the current
treatment session. The parameters used in the previous session are automatically
loaded when the device is switched on again.
(6) Cancel
The menu is exited without saving.
Program screen
1
2
3
4
5
6
1
2
3
4
5
Summary of Contents for ZLipo Med
