24
10.2.3 Installing the pressure chamber seal (PDD)
NOTICE
Non-compliance may result in material damage.
►
Do not slide the pressure chamber seal onto the external thread.
INFORMATION
If the product is used within a pneumatic pressure chamber, e.g. in a pneumatic cylinder or swivel unit, a pressure
chamber seal is required.
►
Screw the pressure chamber seal onto the external thread of the
product.
1
►
Tighten the lock nut.
►
Make sure that the seal is in full contact on both sides.
Ö
This will ensure optimal sealing.
1
Pressure chamber seal
10.2.4 Installing the stop sleeve (PAH)
INFORMATION
►
Please note that a stop sleeve is required for optimal setting of the damping stroke.
►
Please note that the stop sleeve cannot be used in conjunction with the bellows.
INFORMATION
The lock nut is included in the scope of delivery.
►
Screw the lock nut onto the external thread
of the product.
1
2
3
►
Screw the stop sleeve onto the desired
position on the external thread of the
product.
Ö
This is done to set the end stop and the
damping stroke.
►
Counter the stop sleeve using the lock nut.
►
Place the tool on the wrench flats.
1
Lock nut
2
Wrench flats
3
Stop sleeve
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
INSTALLATION AND OPERATING INSTRUCTIONS:
PowerStop
DDOC00335 / b
EN / 2023-08-07
Summary of Contents for PowerStop PHE16X10LSAK-A
Page 2: ......
