Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
12
INSTALLATION AND OPERATING INSTRUCTIONS:
2-jaw parallel gripper, electric, GEP2000IL-03 series
EN / 2021-06-25
DDOC01219 / a
7.2 Installing the product
NOTICE
Non-compliance may result in material damage.
The product can be installed with its base or
side on the mounting piece.
The following work steps must be observed
during installation:
►
Insert centering sleeves
bl
into the
designated fits
5
on the product.
►
Position the product on the designated
mounting piece using the centering
sleeves
bl
.
►
Use the mounting screws
bm
to secure the
product onto the mounting piece.
Ö
Use an adapter plate as needed. For
information on adapter plates, please refer
to the accessories list, available on our
website.
bl
bm
bl
bm
5
5
7.3 Installing the power supply
NOTICE
The cables that are used by Zimmer GmbH feature a minimum bending radius of 10 x the outer diameter.
This bending radius must not be undershot!
►
Do not fall below this bending radius.
►
Secure free-hanging cables to prevent excessive motion loads or pinching.
►
Connect the supply cables to the gripper
and the control system.
Ö
You can find the corresponding supply
cables on our website.
