DECRIPTION OF USE
Installation:
Remove the bracket from the Water Leakage Detector.
At first time to install the product, please remove the plastic tab from the battery compartment
to allow the connection to the terminal.
Water Leakage Detector will be in pairing status when power turns on the first time. This will
cause an LED indicator light to flash once per second for 3 minutes. The LED indicator will
stop flashing and keep on 10 seconds to confirm a successful pairing.
Drill the hole on the desired location then mount the bracket by screws or seal off the 3M
adhesive tape on the bracket then stick it at the desired location.
*Please be noted that the probe should be place on the floor in order to detect water leakage.
Fix the Water Leakage Detector on the bracket as the arrow direction shown. Then the
installation finish.
Use your product:
After powered ON the detector, press & hold the key for 3 seconds to reset the detector, LED indicator
will blink quickly. Once release the key, the detector will reset to factory fresh setting and the signal
light blinks once per second to search a new enabled Zigbee network.
After joining the Zigbee network, the detector will stop blinking and stay on for 10 seconds then turn
off. If no available networks were found within 3 minutes, the detector will stop blinking and turn off.
Once the probe detects a water leakage, the LED Indicator flashes and the alarm beeps once per
second. The alarm signal will be sent to the gateway once every 5 minutes. During the alarm status,
the user can mute the buzzer by using the App. If the sensor still detects a water leak after 10 minutes,
the detector will trigger the alarm again and another signal will be sent to the gateway and the user.
The alarm will be cancelled if the situation as below.
1.
Water leak is controlled/stopped
2.
User presses the mute status by using the app
3.
The button on the sensor itself is pressed
4.
Power is turned off
Details about the alarm system: there are four settings to select from in App (IF DESIGNED IN THE
APP):
1.
0: buzzer muted, LED off
2.
1: buzzer muted, LED flashes
3.
2: buzzer on, LED off
4.
3: Buzzer on, LED flashes (default setting)
