date / name
20.12.1999 Wl/Fz
Z. Nr.: 642 0720.1
sheet 3 of 4
Type: TMS 400
22.12.1999
Subject to technical modifications.
EA - Nr.:
9710.1
Installation - Putting into operation
The plug base can be mounted
•
35 mm mounting rail according to DIN 50 002
•
M4 screws
When installing the device into the switch-gear cabinet, please observe the
max. admissible temperature. Care for both sufficient clearance to other
devices or sources of heat or enough forced draught. Generally
recommended mininum clearance: 2 cm.
Wiring directly to plug base
•
Connect wires as per wiring scheme
•
Plug in electronics and fix with knurled screw
Attention!
Do not plug in device alive nor detach it from socket.
Before switching on make sure that the operational voltage Us of the
lateral type plate and the mains voltage are the same.
Put into operation the thermostat as follows
•
Connect thermocouple.
•
Switch on mains voltage
•
At correct state, the LED lights up ( tempeature lower than the set limit ), contacts 7,8
closed. ( Relay picked up ).
•
Set limit with screwdriver to desired value
•
Relay releases when set temperature is exceeded, the relevant LED is switched off.
