4 Mounting
4.1 General notes
Attention!
•
Check the fan for damage, e.g. cracks, dents or damage to the electric cables, before
assembly. Start-up is not allowed in the case of transport damage!
•
Mounting is only to be undertaken by trained service personnel. The system
manufacturer or the machine builder and/or the user is responsible that the inherent
installation and security information are harmonized with the valid standard and
guidelines (EN ISO12100 / 13857).
•
Do not allow drilling chips, screws and other foreign bodies to reach the device
interior!
•
Prior to installing the fan, it is to be checked whether the safety zone as per EN ISO
13857 and in household appliances as per EN 60335 are met. If the installation height
(danger zone) above the reference level is greater than or equal to 2700 mm and is
not reduced by auxiliary means such as chairs, ladders, work platforms or bases on
vehicles, a guard grille against accidental contact is not necessary at the fan.
•
If the fan is located in danger zone, then the manufacturer or operator shall ensure
that hazards shall be prevented by appropriare protective constuctions which meet
the requirements to EN ISO 13857.
•
The custom designs must suit the prevailing conditions.
•
Tighten the fastenings with the speci
fi
ed torques.
•
Any use below -10
°
C is dependent on not being subjected to unusual, sudden or
mechanical loads or stresses on the material (min. ambient temperature
Technical
data).
•
Corrosion is possible at the cutting edges on sendzimir galvanised parts.
•
The chemical after-treatment of the nozzle can lead to visible residues. These do not
have any technical e
ff
ect however.
4.2 Connection cable & junction box
Info
In demanding environments (wet rooms, outdoor installation), connection cables must
have water draining pipe elbows. If using a junction box, install this lower than the motor
to ensure that water cannot penetrate through to the controller housing from the
connection cables.
Assembly instructions
FE2owlet-ECQ
Mounting
L-BAL-F062-GB 2022/20 Index 004
Part.-No. 00702389-GB
11/24
