Page
34
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating
environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your hard
drive and your system software both support Ultra DMA/33, select Auto to enable BIOS support.
The Choice: Auto, Disabled
Init Display First
This item allows you to decide to active PCI Slot or AGP first
The choice: PCI Slot, AGP.
Onboard FDD Controller
This should be enabled if your system has a floppy disk drive (FDD) installed on the system board and you
wish to use it. Even when so equipped, if you add a higher performance controller, you will need to disable this
feature.
The Choice: Enabled, Disabled.
USB Controller
The Choice: Enabled, Disabled.
USB Key board Support
The Choice: Enabled, Disabled.
VGA Shared Memory Size
- Set the VGA Shared Memory Size option.
The Choice: None, 2 , 4, 8 MB
VGA Memory Clock
- Set the VGA Memory Clock.
The Choice: 66, 75, 83, 100
Onboard Serial Port 1/Port 2
This item allows you to determine access onboard serial port 1/port 2 controller with which I/O address.
The Choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
IR IRQ Address
The Choice: Disable, 3F8H, 2F8H
IR Mode
This item allows you to determine which Infra Red (IR) function of onboard I/O chip.
The Choice: Standard, ASKIR, HPSIR.
IR IRQ Select
The Choice: Disable, IRQ3,IRQ4,IRQ10,IRQ11
Onboard Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Normal EPP (Extended Parallel Port) ECP
(Extended Capabilities Port) CEP+EPP PC AT parallel port Bidirectional port Fast, buffered port Fast,
buffered, bidirectional port.
Select Normal unless you are certain your hardware and software both sup
