Motherboard Installation
Page 10
INSTALLING SYSTEM MEMORY (RAM)
The motherboard supports three 168-pin DIMM. The three 168-pin DIMM sockets are divided into
six banks for single or double side SDRAM DIMM.
3.3V Key
Unbuffered
DRAM Key
Push to remove
DIMM module
Push to remove
DIMM module
64 Bit 168 PIN DIMM Module
Vertically insert
for installation
Fig. 4 168-Pin DIMM Module Installation Diagram
Expansion Cards Installation
At the most of beginning, you must read your expansion card documentation on any hardware and
software settings that may be required. The installation procedures are summarized as below:
1.
Read the User’s Guide/Manual of your expansion card.
2.
If necessary, set any jumpers on your expansion card.
3.
Power-off the system and then disconnected the power cord.
4.
Remove your computer’s cover.
5.
Remove the metal bracket from one of the empty slot, ISA or PCI, corresponding to the
type of expansion card.
6.
Carefully align the card’s connectors and press firmly, make sure at the connection is
good.
7.
Secure the card on the slot.