12
master-testing unit.
4. Once both ends of the cable are plugged in properly, the
second row of LEDs will illuminate according to the
corresponding LEDs in the top row.
5. Read the results of the LED display for the pin
configuration status of the tested cable. If you fail to read
the results the first time in Auto mode, you may wait for the
second LED scan, or simply switch to Manual mode for pin
by pin testing. In Manual mode, pressing the square "Test"
button will advance testing to the next pin.
RJ11 Modular Cable Test
Please follow directions for the UTP/STP Cable Test anduse
the operations manual for the correct LED pin out display
Coaxial Cable Test
1.Plug the two attached BNC adapter cables on both RJ45
jacks. Then connect the tested cable to each end of the
BNC adapter cables
2. For the remaining testing procedures, please refer to
10Base-T Test steps 2 to 5.
Note:
1. The center pin of BNC should be read on LED 2.
2. As Coaxial cable has only two wires, we suggest you read
the result of the LED scan using Manual mode.
Remote Test
1. Plug one end of the tested cable to the transmitting RJ45
jack on the master unit marked with a ' ' and plug the other
end into the remote terminator. If the tested cable is
installed in a patch panel or wall plate, you may use the
included patch cable to solve the connector gender
problem.