Zico QUIC-LIFT HLAS-1200, Parts And Instruction Manual

Page: 18 / 32

-18-
B. Rack Moving in a Jerking Motion or Stops
1. Check fluid level in the hydraulic pump.
2. follow filling procedure (Vii. B. 2.).
VII. MAINTENANCE
A. Periodic
1. Any time the ladder rack and ladders appear to sway, refer to Troubleshooting (Vi. A.) and
follow suggestions depending upon your specific problem.
2. Visually inspect hydraulic system for leaks indicated by the presence of hydraulic fluid or the
accumulation of dirt around a fitting. refer to Checking Hydraulic fluid Level (Vii. B. 2.) before
proceeding.
3. Visually inspect the plastic pads for wear. Pads are located at several points on the ladder rack
assembly and are designed to minimize wear to the ladders. replace as required.
B. Semi-Annually or at Scheduled Apparatus Lube Service
The above items under Periodic maintenance should be checked first and then proceed as follows:
1. Lubricate the following parts as indicated.
a. Joints and pivot points should be sprayed with CRC brand Stor&Lub long term lubricant
and rust preventative #03032. Excess lubrication should be wiped off.
b. Hydraulic ram is self-lubricating and should require no additional lubrication.
c. grease fittings are located on the bottom of the lower shaft (4), one on each side under the
booms, and there is one additional grease fitting in the lower cylinder pin (57). use chassis
lube at these three points.
d. Latch bar (10) and latch (9) should be lubricated with door jam grease where the two parts
come together.