NOTICE: WE SUPPLY YOU INTERLOCK SWITCHES ONLY WHEN YOU PLACE AN ORDER.
5.
5.
5.
5. TABLE'S
TABLE'S
TABLE'S
TABLE'S TINSTALLING
TINSTALLING
TINSTALLING
TINSTALLING AND
AND
AND
AND ADJUDTING
ADJUDTING
ADJUDTING
ADJUDTING
5.1 INSTALLING TABLE see Fig.(1)
Install worktable (#83) according to Fig.(1). Fix the saw mouth (#85) into the center of worktable.
Connect the guide board (#87) with the table use four butterfly screw bolts as Fig.(1). Then make
the square neck bolt (#76) plug in the side guide board through strip-shaper washer (#75). Fix the
upper guide board (#79) and side guide board with washer and butterfly nut.
Put the upper board on the right side of saw blade. Loosen the nuts (#77). Take off the upper guide
board and loosen the butterfly nut (#76). Slip the stand of upper guide board (#74) to the right side
of saw blade (#36). Then fix the upper guide board on the other side of the stand of upper guide
board.
EXERCISE CAUTION! Never force the material into the band saw. You will become familiar with the
saw's features from practice and use. If possible, practice sawing with a piece of wood.
5.2 ADJUDTING TABLE ANGLE see Fig.(2)
1) If working table is to be used at an angle, make sure to install the angle core board.
2) Loosen butterfly nut(#32) and adjust working table to the desired angle using the numbers on the
rotating angle rule(#88)
。
3) Tighten butterfly nut (#73) securely so that the working table will not move during operation.
Summary of Contents for BS14
Page 10: ......
